Home Page

Construction Equipment

Sawmill Equipment

Financing

Personal Currency Assistant™

MLH Machinery

LOG BREAKDOWN EQUIPMENT

1. Nicholson A5 35 inch Debarker Air seal rotor, priced loaded on truck, spare parts.  Needs bottom feed sprockets replaced.

2. Nicholson A5 27" Debarker.  Air seal rotor.

3. Valon Kone 30" self centering infeed conveyor, hydraulic drive, 36"W at top of conveyor, 17 3/4" in chainway, and 14' long

4. Nicholson A5 35 inch Right Hand, 1994 year model

Dip Tank System

1. Installed: 1996 - Tank Size: 10' wide, 20' Long, 94" Deep - Infeed Deck: 21' Long, 13' 6" Wide - Infeed Rollcase: 20' Long, 66" Wide - Infeed Drive: 10 HP - Outfeed Rollcase: 45' Long, 66" Wide - 2 Storage Decks: 20' Long, 11' 3" Wide & 20' Long, 10' 3" Wide - Outfeed Rolls Hydraulic Drive - Hydraulic Unit: 50 HP, 3 Phase, 460 Volts - Cost $230,000 when purchased new. This unit is still completely intact and operational.

1. 18” Galvanized Duct Pipe (approximately 300’)

20” Galvanized Duct Pipe (approximately 300’)

36” Galvanized Duct Pipe (approximately 50’)

48” Galvanized Duct Pipe (approximately 35’)

Some elbows

Salem 3-Saw  Edger

SALEM 3-Saw board edger - 1990 model edger with 60 HP arbor motor, 4" x 48" capacity, 9' dead infeed table, 17' long picker type outfeed table, hydraulic blade shift with HPU, Extra Parts

Tank 1 (Left Side)

Length – 43’ without ends

Diameter – 6’6”

Hydraulic Door – Yes

Carts – Yes

Baffles – No

Hydraulic Pump – Yes

Vacuum Pump – Yes (Optional)

                Nash Type XL15077   Year: 2005

                Total hours: 26.4

Piping – One 6” pipe coming out of the top, 16’ from the back end  

Tank 2 (Right Side)

Length – 43’ without ends.

Diameter – 6’6”

Hydraulic Door – Yes

Carts – Yes

Baffles – No

Hydraulic Pump – Yes

Vacuum Pump – Yes (Optional)

                Nash Type XL15077  Year: 2005

                Total hours: 5.2

Piping – One 6” pipe coming out of the top, 9’ from the front end.